It's a fairly minimalistic, but self-contained, 3D printer. You might want to use it to "repstrap" a replacement printer at some point -- but you at least start with a basic set of electronics, motors, rods, and bearings. Toward the end of the video, you can see the high-test line...
Read MoreSorry, not the greatest video - but if you look carefully, you can see the banding and voids that formed on this matrix-lattice art piece. It was roughly 5 inches cubed. In the background, you can hear one of the Form 1 folks talking about people developing skin sensitivity to...
Read MorePrototype Z-Corp style powder printer by SandBox. Inkjet wetting of plaster to make parts. I think this approach will really take off when Memjet nozzles (video below - warning, turn your volume down) becomes readily available and repurposed for 3D printing.. In theory, it should be possible to print ~0.1mm resolution...
Read More
Check out our selection of high quality filament
for all of your 3D project needs! Shop now!
Shop ToyBuilder Labs